Xenotech BRITELIGHT 10000AR, Руководство по установке

Страница: 3 / 21

PAGE 3
BRITELIGHT 10000AR INSTALLATION INSTRUCTIONS
NOTE
THE BL10000AR SYSTEM SHOULD BE INSTALLED BY AN ELECTRICAL CONTRACTOR FOLLOWING ALL APPLICABLE
ELECTRICAL AND BUILDING CODES FOR THE INSTALLATION SITE.
UNPACKING
BASE UNIT
1. REMOVE THE SYSTEM BASE FROM IT'S SHIPPING PALLET BY REMOVING THE 4 RETAINING BOLTS FROM THE
BASE FOOTINGS AND LIFTING THE SYSTEM FROM THE PALLET.
2. POSITION THE SYSTEM BASE IN THE LOCATION THAT IT WILL BE OPERATING AND CHECK THE SYSTEM FOR
STABILITY. IT IS RECOMMENDED THAT THE SYSTEM BE BOLTED DOWN TO THE MOUNTING SURFACE. IF THE
SURFACE IS UNEVEN IT MAY BE NECESSARY TO SHIM THE FOOTINGS OF THE BASE UNIT TO STABILIZE THE
SYSTEM.
3. WHEN POSITIONING THE SYSTEM BE SURE TO ALLOW ADEQUATE CLEARANCE FOR THE AIR INTAKES AND
EXHAUSTS ON BOTH THE BASE AND HEAD UNITS AND ALSO ADEQUATE CLEARANCE TO THE FRONT AND
BACK OF THE BASE UNIT FOR SERVICE AND FOR A FULL RANGE OF MOTION OF THE LAMP HEAD.
LAMP HEAD
1. UNPACK THE LAMP HEAD BY UNWRAPPING IT AND CUTTING THE BANDING STRAPS.
2. REMOVE TWO ADJACENT LAMP HEAD RETAINING CLAMPS FROM THE TOP OF THE BASE AND LOOSEN THE
TWO REMAINING CLAMPS IN PREPARATION FOR MOUNTING THE LAMP HEAD.
3. LIFT THE LAMP HEAD FROM THE PALLET AND POSITION THE SUPPORT PLATE UNDER THE TWO MOUNTING
CLAMPS ON THE TOP OF THE BASE. POINT THE LAMP HEAD IN THE DESIRED OPERATING DIRECTION AND
INSTALL THE REMAINING CLAMPS.