Xenotech BRITELIGHT 10000AR, Руководство по установке

Страница: 15 / 21

PAGE 15
FOCUS AND X-Y ADJUSTMENT INSTRUCTIONS
FOR SYSTEMS W/ ELECTRIC FOCUS
NOTE
FAMILIARIZE YOURSELF WITH THE LOCATION AND IDENTIFICATION OF THE COMPONENTS OF THIS SYSTEM AND
ALSO THE NORMAL OPERATION OF THE SYSTEM BEFORE ATTEMPTING ANY ADJUSTMENT OR SERVICE.
NOTE
COMPLETELY READ THROUGH AND HAVE A GOOD UNDERSTANDING OF THE PROCEDURES BEFORE
ATTEMPTING TO SERVICE THIS SYSTEM. FAILURE TO DO SO MAY RESULT IN FATAL INJURY OR EQUIPMENT
DAMAGE.
EQUIPMENT REQUIRED
1. ALLEN WRENCH 5/32
2. # 5 WELDERS GLASSES OR VERY DARK SUNGLASSES
WARNING
THE SUPER 10 SYSTEMS PROJECT A VERY INTENSE BEAM OF FULL SPECTRUM LIGHT. THE USE OF DARK GLASSES
WHILE ADJUSTING THE BEAM PARAMETERS ON A LIGHT COLORED REFLECTIVE SURFACE AT A CLOSE DISTANCE
IS REQUIRED.
WARNING
NEVER LOOK DIRECTLY INTO A LIT FIXTURE'S LIGHT SOURCE.
ADJUSTMENT INSTRUCTIONS
1. LOOSEN THE POSITIONING FASTENERS AND POINT THE LAMP HEAD TOWARD A WALL, CEILING, OR OTHER
FLAT SURFACE AT LEAST 10 FEET AWAY.
2. LOCATE THE FOCUS SWITCH LOCATED ON THE REAR OF THE LAMP HEAD.
3. REMOVE THE FRONT COWL AND LOCATE THE X & Y ADJUSTMENT HOLES LOCATED ON THE LOWER SMALL
SIDES OF THE FIXTURE AT THE ENDS OF THE FRONT SPIDER ARMS.
WARNING
THE SUPER 10 SYSTEMS PROJECT A VERY INTENSE BEAM OF FULL SPECTRUM LIGHT. CAUTION MUST BE TAKEN
WHEN POINTING THE BEAM AT AN OBJECT AT A DISTANCE OF LESS THAN 100 FEET WITH THE FOCUS SET FOR A
CONVERGING BEAM. COMBUSTIBLE OBJECTS AND OBJECTS WITH A DARK COLOR MAY UNEXPECTEDLY
IGNITE IF CARE IS NOT TAKEN IN THE FOCUSING AND POSITIONING OF THE BEAM.
4. ENERGIZE THE FIXTURE AND IGNITE THE LAMP.
5. ADJUST THE FOCUS BY MOVING THE FOCUS SWITCH UP OR DOWN TO PRODUCE A DIVERGING BEAM
PATTERN WITH 2-3 CLEARLY DEFINED RINGS OF LIGHT WITH OR WITHOUT AN OFF CENTER HOT SPOT.
6. ADJUST THE X & Y ADJUSTMENT SCREWS USING A 5/32 ALLEN WRENCH TO MOVE THE INNER RINGS OF
LIGHT TO CREATE CONCENTRIC RINGS WITH THE HOT SPOT AT THE CENTER OF THE LIGHT FIELD. TURNING
THE ADJUSTMENT SCREW CLOCKWISE WILL MOVE THE RINGS TOWARD THAT ADJUSTMENT AXIS AND
TURNING THE SCREW COUNTERCLOCKWISE WILL MOVE THE RINGS AWAY FROM THAT ADJUSTMENT AXIS.
7. READJUST THE FOCUS SCREW TO SET THE DESIRED BEAM SPREAD.
8. REPLACE THE FRONT COWL REPOSITION THE LAMP HEAD AND RESECURE THE POSITION LOCKING
FASTENERS.