Installation and Users Guide: XenData SX-10 Archive Appliance
Page 13
Chapter 4. Power-On and Power-Off Procedures
4.1 System Power-On
It is important that the LTO drive or tape library is powered on and is ready before the SX-10 boots.
Please follow the procedure described below.
1. Power on the LTO tape drive or library and wait until it comes ready.
2. Power on the SX-10 using the power push button.
4.2 System Power-Off
For a system with one or two stand-alone LTO tape drives, please follow the procedure described
below.
1. Ensure that all LTO drive write and read operations have completed.
2. Power off the SX-10 using ‘Shut down’ from the Start menu.
For a system with a tape library, please follow the procedure described below.
1. Ensure that all write and read operations to LTO have completed.
2. Ensure that there are no tape cartridges in any of the tape drives in the tape library. If
necessary wait until the drives unload automatically. (The XenData software, by default, will
unload tape cartridges after 10 minutes of inactivity.)
3. Power off the SX-10 using ‘Shut down’ from the Start menu.
XenData, Inc., 2125 Oak Grove Road, Suite 100, Walnut Creek, 94598 California, USA
Phone: +1 925 465 4300 Email: [email protected] Web Site: www.xendata.com
