14
VIPER MIG 135
OPERATING MANUAL
7. MIG: Machine Setup (Gas-Shielded)
ON
OFF
GAS IN
1.
Connect the polarity cable to the
positive (+)
dinse
connection, twist to lock in place.
2.
Connect the earth clamp to the
negative (-)
dinse
connection, twist to lock in place.
3.
Connect the plug into a 10 AMP power point, then
switch the machine ON.
4.
Pull up the roller tension knob to release the wire
drive.
5.
Unscrew the roller cap.
6.
Ensure you have a V Groove drive roller installed. If not,
fit correct roller and replace the roller cover.
