Xantrex PV225S-480-P, Руководство по эксплуатации и обслуживанию

Страница: 64 / 126

Operation
2–24 152607
Energize Procedure (Startup)
To start up the PV225S:
1. Remove any lockout devices from the Utility connection circuit breaker and
PV disconnect switch.
2. Close the Utility connection circuit breaker.
3. Close the AC Disconnect Switch.
4. Close DC Disconnect Switch.
5. Turn the
ON
/
OFF
switch to the
ON
position.
After a 15 second initialization period, the PV225S will automatically transition
to ‘Waking Up’, given the PV voltage is greater than the PV V Start set point.
De-Energize/Isolation Procedure (Shutdown)
The following procedure should be followed to de-energize the PV225S for
maintenance:
To isolate the PV225S:
1. Turn the O
N
/O
FF
switch to the O
FF
position.
2. Open the DC Disconnect Switch.
3. Open the AC Disconnect Switch.
4. Open the utility connection circuit breaker.
5. Install lockout devices on the utility connection circuit breaker and DC
Disconnect Switch.
WARNING
The terminals of the DC input may be energized if the PV arrays are energized. In
addition, allow 5 minutes for all capacitors within the main enclosure to discharge after
disconnecting the PV225S from AC and DC sources.