Xantrex GPIB-XPD, Руководство по эксплуатации

Страница: 22 / 58

Installation and Configuration
IEEE-488 Primary Address Selection
20
Operating Manual for GPIB for XPD Series Power Supply
IEEE-488 Primary Address Selection
1. Assign a primary address to each power supply: Choose a number between 0 and
30 which is unique to your IEEE-488 bus, that is, different from other device
addresses on the same bus.
2. Locate switch S1 on the GPIB interface rear panel. See “GPIB Interface
Subplate” on page 17 for the interface subplate drawing.
3. Use switch positions A1 to A5 to set the primary address for the power supply.
See Table 2.2, “IEEE-488 Primary Address Selection”.
Switch 0 = (OFF, OPEN) Switch 1 = (ON, CLOSED)
Table 2.2 IEEE-488 Primary Address Selection
Note: Ensure you assign one address to each GPIB controller board as well.
Address A5 A4 A3 A2 A1 Address A5 A4 A3 A2 A1
0 0 0 0 0 0 16 1 0 0 0 0
1 0 0 0 0 1 17 1 0 0 0 1
2 0 0 0 1 0 18 1 0 0 1 0
3 0 0 0 1 1 19 1 0 0 1 1
4 0 0 1 0 0 20 1 0 1 0 0
5 0 0 1 0 1 21 1 0 1 0 1
6 0 0 1 1 0 22 1 0 1 1 0
7 0 0 1 1 1 23 1 0 1 1 1
8 0 1 0 0 0 24 1 1 0 0 0
9 0 1 0 0 1 25 1 1 0 0 1
10 0 1 0 1 0 26 1 1 0 1 0
11 0 1 0 1 1 27 1 1 0 1 1
12 0 1 1 0 0 28 1 1 1 0 0
13 0 1 1 0 1 29 1 1 1 0 1
14 0 1 1 1 0 30 1 1 1 1 0
15 0 1 1 1 1