Xantrex 817-1000, Руководство пользователя

Страница: 30 / 82

Using the correct cable size is critical to achieving the rated
performance of the Freedom X unit. When starting a heavy load the
Freedom X can draw current surges from the battery of up to 400A. If the
DC wiring is too small the voltage drop from this surge will result in a
voltage at the Freedom X terminals that is too low for the Freedom X to
operate correctly. The Freedom X may appear to operate correctly with
smaller cables until a heavy load such as a microwave or refrigerator
attempts to start - then the unit may work correctly sometimes and not work
correctly other times.
16 Freedom X Owner’s Guide
Basic Installation Procedures
DC Disconnects and Over-Current Devices
The DC circuit from the battery to the Freedom X must be equipped
with a disconnect and over-current device. This usually consists of a
circuit breaker, a “fused-disconnect”, or a separate fuse and DC
disconnect. Do not confuse AC circuit breakers with DC circuit
breakers. They are not interchangeable. The rating of the fuse or
breaker must be matched to the size of cables used in accordance
with the applicable installation codes. The breaker or disconnect
and fuse should be located as close as possible to the battery, in the
positive cable. Applicable codes may limit how far the protection
can be from the battery.
Batteries
The Freedom X uses 12-volt battery banks. Every Freedom X
system is recommended to have a deep-cycle battery or group of
batteries with a total capacity of 100 Ah or more which provides the
DC current that the Freedom X converts to AC.
Ground Fault Circuit Interrupters (GFCIs)
A GFCI is a device that de-energizes a circuit when a current to
ground exceeds a specified value that is less than that required to
blow the circuit breaker. GFCIs are intended to protect people from
electric shocks and are usually required in wet or damp locations.
Installations in marine and recreational vehicles require GFCI
protection of branch circuits connected to the AC output of the
Freedom X.
The Freedom X GFCI Device (PN: 808-9817) is available to use
with the Freedom X inverter unit.
Important:
Freedom X Series INV Owners Guide.book Page 16 Tuesday, June 27, 2017 4:10 PM