2-34 Installation
bb
_________________________________________
Setting the EtherTalk Zone Name
Check with your system administrator to see if you need to set an
EtherTalk zone name. If you need to set the EtherTalk zone name to
a name other than the default name supplied by your router, you can
do this by creating and downloading a PostScript file to the printer.
You can use the Adobe Font Downloader in the XANTÉ Utilities to
send this file to the printer.
When you create the file, zone names are limited to 32 characters
and should not contain the equal sign (=), the approximately equal
sign (
≈
), and the asterisk (*). For example, to name your zone
“Marketing - First Floor” using the procedure later in this section,
you would type the following in step 3.
(%EtherTalk_NV%) << /EtherTalkZone (Marketing-First
Floor) >>setdevparams
Note:
Check with the system administrator to find out what zone
name to use.
To set the EtherTalk zone name, use the following procedure.
1.
Open the TeachText program which came with your
Macintosh.
2.
Select New from the File menu.
3.
Type the following file substituting the name for the zone used
on your network for
nameofzone
.
(%EtherTalk_NV%)<</
EtherTalkZone(nameofzone)>>setdevparams
4.
Select Save from the File menu, and save the file as Set
Zone.ps on your host system.
5.
Select Quit from the File menu to exit TeachText.
6.
Insert the Macintosh XANTÉ Utilities disk included with your
printer.
7.
Open the Utilities folder.
