X-TREME XB-420M, Руководство пользователя

Страница: 30 / 43

29
How To Understand Charger Light Sequence
- When you plug your charger into the wall the light should turn Green.
- Plug your charger into the scooter and it should turn to Red for a good
period of time.
*** This indicates that the charger sees the batteries and charge cycle started.
- If No Red light then charger is not making a connection to batteries to
charge them. Check for a loose wire on the back of the charge socket or bad
fuse/fuse holder.
- If the charger just turns Red for a minute or two, this may indicates a
defective cell in one of the batteries and batteries will need to be replaced.
*** A defective cell reacts like a fully charged battery and will bring other
batteries down to its level.
- If a flashing Red light appears on the charger, this may indicate the charger
wires are crossed and/or touching each other.
*** In most cases if the scooter runs a shorter distance the batteries may be
beyond their life cycle.
How To Replace A Controller
1.
Remove Main Fuse.
2. Gain access to where the Controller is located.
3. Place the New Controller alongside the Original Controller.
4. Disconnect and re-connect One (1) Connector at a time. We
recommend starting with the Largest Connector and working down
to the Smallest Connector. This will avoid confusing the
connectors.
5. With the Original Controller free of all wire connectors remove
from frame.
6. Install the New Controller in its place with the original screws if
equipped or with Double Sided Tape.
7. Install Main Fuse.
8. With drive wheel NOT touching any surface test run the motor and
check accessories to confirm that they are functioning correctly.
9. Re-assemble and test ride. This is also a good time to perform a full
check of the brakes, tire air pressure, etc.