FIGURE 1
This instruction manual complies with ASTM F2123 Standard Practice for Treestand Instruction.
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
STEP 1.
Select a straight, healthy tree, one devoid of dead branches or loose bark.
DO NOT
attempt to install this peoduct on a tree that is not healthy!
Top Ladder Section Middle Ladder Section Bottom Ladder Section
Top Ladder
Section
Safety Sleeve
[B]
[B]
Safety
Sleeve
Middle Ladder
Section
FIGURE 2
FIGURE 3
STEP 2.
Assemble ladder sections beginning with top ladder section. Attach middle
ladder section to top ladder section. Attach bottom ladder section to the middle
ladder section. Each ladder section has slight design differences (Fig. 1) and need to
be assembled in the proper order for correct installation.
After assembling the ladder,
secure using (4) 1/4"x 1 3/4" hex bolts (B), (8) nylon washers and (4) 1/4" nylock nuts.
NOTE:
All ladder section will be assembled with the male end facing upward and fe-
male end (sleeves) facing downward (Fig. 2). The safety sleeves will be visible on the
outside
of the ladder section connection joints.
Rear Frame Support
Cam Buckle Strap
Bark Biters
STEP 3.
Attach the two (2) long ends of the cam buckle
straps to each side of the rear frame support (near the
bark biters).
Secure straps by wrapping straps around
rear frame support and pulling through its looped end.
(Fig. 3) Then attach the two (2) ends of the cam buckle
straps with cam buckle to each side of the middle
ladder section column tubing (beneath the 5th rung up
as counted from the ground). Secure straps with cam
buckle by wrapping strap around vertical ladder leg
and pulling through its looped end. (Fig. 4) Feed the
free ends of the long straps through cam buckle and
tighten the cam buckle straps securely (see cam buckle
instructions).
NOTE:
DO NOT
attempt to install your
ladderstand without the straps firmly tied to the ladder.
NOTE: SECURELY TIGHTEN
EVERY NUT AND BOLT AT
THIS TIME.
