X-Rite MA-T12, Руководство пользователя

Страница: 11 / 36

M A - T 6 / M A - T 1 2 S P E C T R O P H O T O M E T E R
9
4.
Lower the battery pack into position and slide it toward the LED (2) until it stops. Depending
on the battery packs current charge state, the LED will illuminate "red", "amber", or "green"
when properly seated.
5.
After charging is complete, slide the battery in the opposite direction of the LED until it stops
and lift upward to remove.
Connecting the AC Adapter
NOTE: The instrument can operate from the AC adapter only. The battery pack does not need to be
installed. The AC adapter (X- Rite P/N SE30 -277) overrides any charge condition of the battery pack in the
instrument. Measurements can be taken even with a very low battery condition when using the AC
adapter and the battery pack is charging.
1.
Verify the voltage indicated on the AC adapter complies with the AC line voltage in your area.
2.
Open the access cover (1) at the back of the instrument.
3.
Insert the small plug from the AC adapter (2) into the input connector on the instrument.
4.
Plug the detachable line cord in the AC adapter and plug the line cord into the wall receptacle.
AC Adapter Ratings
Input: 100-240V 50-60 Hz
Output: 12VDC @ 2.5A
Operational hazard
exists if an AC adapter
other than X-
Rite P/N
SE30-277 is used.
(3)
(1)
(2)
(4)