6. GENERAL FUNCTIONING OF THE CONTROL PANEL
6.1 General functioning
SETUP PRESS
PAGE + MAN 10s
ON
400 V
13.2 A 13.2 A
}
6.2 Application pressure booster
AUTOMATIC MOT. 1
13.2 A 0h
STOP MOTOR 1
0.0 A 0h
6.1
START PRESS. ON
EMERG. PRESS. OFF
START ON: ENABLES THE FIRST MOTOR
START OFF: DISABLES THE FIRST MOTOR
EMERG.ON: ENABLES THE SECOND MOTOR
EMERG.OFF: DISABLES THE SECOND MOTOR
MANUAL MOTOR 1
13.2 A 0h
32
IGNITION
CONTROL PANEL
THIS SCREEN IS DISPLAYED ONLY IF THE MAINS
SUPPLY WAITING FUNCTION IS ENABLED
IN THE SETUP MENU. TO EXCLUDE THE
WAITING TIME PRESS
RESET
MAINS WAIT. 1 m
RESET TO START
THE OPERATION SCREENS RELATING TO THE CHOSEN
APPLICATION ARE DISPLAYED BELOW
PRESSURE BOOSTER = SEE CHAPTER 6.2
CLEAN WATER = SEE CHAPTER 6.3
SEWAGE = SEE CHAPTER 6.4
4-20mA bar = SEE CHAPTER 6.5
4-20mA meters = SEE CHAPTER 6.6
IT IS USED TO START THE MOTORS MANUALLY
ONLY IN STABLE MANUAL
BUTTON MODE
AUTOMATIC MOT. 2
13.2 A 0h
STOP MOTOR 2
0.0 A 0h
MANUAL MOTOR 2
13.2 A 0h
NO WATER
WAITING
FILLING
THIS SCREEN IS DISPLAYED WHEN
THE MINIMUM PROBE IS DISCOVERED
THIS SCREEN IS DISPLAYED WHEN THE
MINIMUM PROBE IS COVERED AND
THE MAXIMUM PROBE IS DISCOVERED
AFTER THE LACK OF WATER
IF THE MOTHERBOARD DETECTS
A DRY RUNNING CONDITION IT
WILL BE POSSIBLE TO DISPLAY
A FOURTH SCREEN
It is used to scroll through the pages
Pressed in MOTOR STOP status it starts the motor
in manual mode
Pressed it starts the motor in automatic mode
Pressed the motor goes in STOP function
Pressed in case of an alarm it resets it
THE FOLLOWING SCREEN DISPLAYS:
- MEASURED VOLTAGE
- ABSORBED CURRENT OF THE MOTORS
- OPERATING HOURS OF THE MOTORS