6
STROLLER UNFOLDING
Unfasten a locking block (a). Unfold the stroller lifting the handle up, until locks snap (b).
WARNING: Before using the stroller, make sure that all folding mechanisms are locked.
STROLLER FOLDING
Pull the handles on the handle bar (a). Fold the stroller by holding the handle as shown
in figure (b) until the locking block is locked (c).
FRONT WHEEL ASSEMBLY
To assemble a wheel, insert it on the axis until the lock snaps.
FRONT WHEEL DISASSEMBLY
To remove a wheel, press the button shown in figure (a) and remove it from the axis (b).
FRONT WHEEL LOCK
The stroller is equipped with swivel wheels. The button shown in figure is used to lock
rotation. When pressed, it locks the wheels to drive in a straight direction. To unlock the
wheel, press the button again.
HANDLE BAR ADJUSTMENT
To change the position of the handle bar, press the buttons on the sides and change
the position.
BRAKE
To lock the wheels, press the brake lever in its closer part (a). To release the brake, press
the brake lever in its distant part (b).
GUARDRAIL ASSEMBLY
Place the ends of the guardrail into the mounting holes until the locks snap.
GUARDRAIL DISASSEMBLY
Press the lock buttons of the guardrail and remove guardrail ends from the mounting holes.
The guardrail can be bent back by unfastening it from one side only.
ASSEMBLY AND DISASSEMBLY OF THE STROLLER CANOPY
To place the canopy, insert its clips into the mounting holes (a).
To remove the canopy, press the clip locks and remove the canopy from the mounting
holes (b).
RECLINING SEAT ADJUSTMENT
To lower the seat, squeeze the lock lever and move the seat down (a).
To lift the seat, grab the belt with one hand, and squeeze the lock lever with other hand
and move the seat up (b).
FOOTREST ADJUSTMENT
To change the footrest position, press the buttons located under the footrest and
change its position.
FASTENING THE STROLLER COVER.
Install the cover starting from the footrest and fasten snaps in the places shown in figure.
BELT BUCKLE
To fasten the belt buckle, slide the belt lock into the slot and press it down until it snaps
into place (a). Repeat this procedure for all locks. To unfasten, press the round button
until the moment when the locks are released from the buckle latch (b).
BELT ADJUSTMENT
To adjust the belt length, move the belt towards a regulator. Regulators are hidden under
protective covers.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
ENGLISH
