X-IO Hyper ISE, Руководство пользователя

Страница: 30 / 178

Page 22 160337-000 Rev D, 30 September, 2013 Xiotech—Proprietary
ISE User Guide Installation
SFP Installation
When additional SFP (Small-Form-Factor Pluggable) Fibre Channel connector modules are purchased, instal-
lation is required. Install SFP modules using the following procedure:
1. Remove the protective plug from a port on an ISE MRC—three ports are available on each MRC.
2. Gently insert the replacement SFP fully into the chassis. If a solid resistance is encountered, remove the
SFP, turn it over, and re-insert it.
3. When the SFP is fully inserted, engage the bail if needed to secure it in the MRC. When properly seated,
the SFP is flush with the MRC latch handle.
4. Insert a Fibre Channel cable gently into the SFP while gently pinching the cable connector.
Service Console
The very first time an ISE is powered on, a service console is required to determine or change the IP
addresses. The service console can be a laptop or other computer that provides serial port connectivity. Con-
nect the computer to one of the serial ports on the ISE with the supplied serial cable.
Note.
A single cable can be plugged into either service console port.
With a service console connected, follow the procedure below to establish a service console connection:
1. Open a terminal emulation application on the service console.
2. Set the terminal emulation application properties for the appropriate COM port as shown in Table 3.
Table 3: COM Port Settings
3. Press
E
NTER
on the service console (or use whatever method is provided by the application in use) to
initiate a terminal console session and receive a login prompt from the ISE (Figure 21 on page 25).
Management Console
The ISE management console is accessed through the Ethernet network using either or both ISE IP addresses
(see “Reserved Characters” on page 29 and “Command Line Interface” on page 35).
Orchestrator
Orchestrator provides storage management and provisioning services for ISE Storage Blade systems. This
replaces the ISE Web Management interface (Classic View) on ISE-2 and ISE-3 systems and approaches ISE
management from a global perspective. All managed ISEs are listed in the left navigation pane and are
accessed by clicking on an ISE name. Orchestrator also presents statistics for the entire field of networked
ISEs. See the
Orchestrator User Guide
for details.
Setting Value
Bits per second (Baud rate) 115200
Data bits 8
Parity bit none
Stop bit 1
Flow control none
Any other settings default