Tel: +49 (0) 8641 6948 - 60 | xgloo.com | [email protected]
29
XC 3
The XC 3-model Event Tent can be easily disassembled
into individual parts (Roof and Tubes) for repair or re-
placement. Re-attaching the new or repaired part is
just as easy.
REMOVING THE ROOF
1 Unhook the plastic toggle from the loop at the end
of each Tube (a).
2 On the Roof-Tube connectors, hook one finger bene-
ath one of the points (using the recessed grip for this
purpose (b)) and then completely unthread the cord.
Repeat this on all of the remaining Roof-Tube con-
nectors and then the Roof can be removed.
SEPARATING THE TUBES
1 Remove the Roof as described above.
2 Use a 5mm allen key to unscrew the bolt in the tube
connector and then remove the bolt and cap (c). The
Tubes can then then be easily removed by sliding
them out of the channels in the tube connector (d).
RE-ASSEMBLY
To reassemble the Event Tent, simply reverse the disas-
sembly process. When placing the Tubes into the tube
connector, make sure to leave every second channel
open (d).
To reattach the Roof to the Roof-Tube connectors, first
thread the cord crosswise into the center of each con-
nector (e) and then through both both ends of the
channel until it slips under each of the two points.
Finally, replace the toggles through the loops at the
end of each Tube.
REPAIR
c
d
e
b
a
