11
US/CAN/MEX: +1-518-289-1294 Toll Free Technical Support: +1-844-280-WYRE (9973)
1
3
IP Settings
The matrix can also be controlled over LAN, through
which it may be accessed though Web GUI or Telnet after
obtaining the matrix IP address. By default, the IP address
to access the matrix is assigned automatically by the
router or switch with a DHCP server.
Obtaining an IP Address Automatically
Click IP SET in the Set Panel area to allow access to
IP functions and obtain / store the IP address.
Select Automatically obtain IP address to enable the
IP address to be detected automatically by the system.
This option is selected by default.
Click OK to store the IP address and click to
exit.
Set a Static IP Address
Click IP SET in Set Panel area to allow access to IP
functions to obtain and store the IP address.
Select Set static IP address to manually input the IP
functions if no address appears or if the system is unable
to detect an IP address. Enter an IP address (such as
192.168.10.8) ensuring the IP addresses of the matrix
and your computer are in the same subnet segment.
Click OK to store the IP address and click to
exit.
EDID Settings
The EDID SET window allows users to access and
configure EDID settings that can be read, written, saved
and recalled, with optimized viewing achieved by writing
the output port of a particular display to a specific input
port.
NOTE
EDID cannot be read from matrix output
ports not connected to a display – check matrix
outputs are connected to displays before attempting
to read EDID.
Click EDID SET in Set Panel area.
Select an output port from the Port Select area –
such as output port 4 in this case.
Click Read to read EDID from the selected output
port, with the status bar indicating percentage of read
progress.
RS232 CONTROL
1
2
3
1
2
2
3