WYLER BlueLEVEL, Руководство пользователя, Страница: 8 / 84

page 8 of 84
2.2 I
NITIAL START
-
UP OF THE INSTRUMETNS
General remarks for instruments with wireless data transmission:
•
The operation "Combine a group of Instruments" described in chapter 2.4 has already been done at
WYLER's when the instruments are delivered.
•
If a configuration is shut off, e.g. after completion of a measurement, the group-setup remains saved.
When started again, the communication will be re-activated immediately, i.e. no new grouping will be
required.
•
If the group of instruments is extended or amended, e.g. by adding or exchanging an instrument, the
new instrument must be joined to the group as described in chapter 2.4 "Combine a group of
instruments"
First time start-up of a measuring group (BlueLEVEL BASIC and BlueMETER BASIC) with radio transmission
(wireless transmission of the measuring data)
1. Remove the instruments carefully from the transport and storage case and insert the batteries
2. For groups of instruments with wireless data transmission (BlueLEVEL BASIC and BlueMETER BASIC)
the instruments are delivered in a set-up enabling them to recognise each other after the start-up
3. Place the instruments on a clean horizontally aligned surface. Switch on the instruments (BlueLEVEL BASIC
and BlueMETER BASIC). Press the two keys <ON/OFF> and <ON> on either side of the BlueLEVEL BASIC
simultaneously respectively the key <ON/MODE> on the BlueMETER BASIC until all 5 LEDs are on. When
you release the keys "SYSTEM TEST" will appear on the display.
If the two keys <ON/OFF> and <ON> of the BlueLEVEL respectively the key <ON/MODE> of the
BlueMETER BASIC are pressed longer than 10 seconds when starting the instrument, all the LEDs start
blinking and thus the automatic shut-off system is deactivated. In the standard mode the instrument is
shut-off automatically after 60 minutes
4. The instruments are now communicating and after a few seconds the measured values will appear on the
display of the BlueMETER BASIC. The battery power should be checked (see below)
5. The actual measurement may now be started
First time start-up of a measuring group (BlueLEVEL BASIC and BlueMETER BASIC) without radio
transmission (transmission of the measuring data by cables)
1. Remove the instruments carefully from the transport and storage case and insert the batteries
2. Place the measuring instruments on a clean horizontally aligned surface. Connect the instruments
(BlueLEVEL BASIC and BlueMETER BASIC) with the cable(s) supplied
3. Switch on the instruments. Press the two keys <ON/OFF> and <ON> on either side of the BlueLEVEL BASIC
simultaneously respectively the key <ON/MODE> on the BlueMETER BASIC until all 5 LEDs are ON. When
you release the key(s) "SYSTEM TEST" will appear on the display
If the two keys <ON/OFF> and <ON> of the BlueLEVEL respectively the key <ON/MODE> of the
BlueMETER BASIC are pressed longer than 10 seconds when starting the instrument, all the LEDs start
blinking and thus the automatic shut-off system is deactivated. In the standard mode the instrument is
shut-off automatically after 60 minutes
4. The instruments are ready without delay and after a few seconds the measured values will appear on the
display of the BlueMETER BASIC. The battery power should be checked (see below).
5. The actual measurement may now be started
Remarks concerning the battery power:
BlueMETER BASIC
Display of the actual battery
power
(Example:
3,6 V)