WYLER BlueLEVEL-2D, Руководство пользователя, Страница: 26 / 65

page 26 of 65 pages
3.7 G
ROUPING OF INSTRUMENTS TO A MEASURING GROUP IN THE WIRELESS MODE
3.7.1 G
ROUPING VIA CABLE CONNECTION
/ JOIN
1. Connect all instruments to be grouped
(BlueLEVEL-2D and e.g. a BlueMETER
SIGMA or BlueTC) using the cables provided
and switch all instruments on.
2. Select on the BlueMETER the menu "JOIN" using the key. Confirm with the key
. All instruments connected are now searched and joined to a group.
3. After establishing the group a "REFRESH" will be performed.
4. After a successful grouping on both instruments the green LED "READY" will blink shortly as
many times as instruments are joined in the measuring group (including the own address) .
5. For using the wireless mode (the wireless mode must be switched -on on each instrument) the
cables can now be removed. After removing the cables the measurin g values will be "freezed"
for a short while and replaced by empty zeroes until, after successful connection, the measuring
values will be displayed again .
6. After successful connection the blue LED "LINK" will be lighting on all the instruments
connected.
3.7.2 G
ROUPING IN THE WIRELESS MODE
/ JOIN
With the function "JOIN" an instrument can be added to an existing group. During this procedure no
instrument must be connected by cables as otherwise the "JOIN" procedure for cables will be
performed. To make sure that the instrument does not belong to another group, it is advisable to
perform the function "LEAVE" first.
1. On the BlueLEVEL-2D select the menu "JOIN"
using the key. Confirm with
.
Set the second instrument also to the JOIN mode.
2. Searching
The two instruments are "searching" each other. During the searching procedure the green LED
on both instruments is lit continuously. The instruments remain in the "search" mode until they
have detected each other.
During the search process the following picture will be displayed:
Remark: The searching process may go on for several minutes in bad communication conditions.