3-2
NBB-1600 Series: Network Boot Bars - User's Guide
When the NBB is shipped from the factory, RS232 Port Parameters are set as
follows: 9600 bps, 8 Data Bits, One Stop Bit, No Parity. Although the NBB
allows these parameters to be easily redefined, for the purpose of this Quick
Start procedure, it is recommended that you configure your communications
program to accept these default parameters.
3.2. Communicating with the NBB
The NBB offers two separate user interfaces: the Web Browser Interface and
the Text Interface. The Web Browser interface allows you to contact the NBB
via a TCP/IP network, using a standard, JavaScript enabled web browser (such
as Internet Explorer.) The Text Interface consists of a series of ASCII text
menus, which may be accessed via TCP/IP network, Local PC or modem.
Note:
The NBB features a default IP Address (192.168.168.168)
and a default Subnet Mask (255.255.255.0). This allows initial
network access to command mode without first setting up network
parameters (providing that you are contacting the NBB from a node
on the same subnet.) When attempting to access the NBB from a
node that is not on the same subnet, please refer to Section 5.3.4 for
further configuration instructions.
1.
Access Command Mode:
This procedure differs slightly for the Web
Browser Interface and Text Interface:
a)
Web Browser Interface:
Start your JavaScript enabled Web
Browser. Enter the NBB’s default IP address (192.168.168.168)
in the address bar, then press
[Enter]
. A password prompt will be
displayed. Since at this point, the username and password have not
been defined, you can simply click OK without entering a username
or password. The Plug Status Screen will be displayed as shown in
Figure 3.1.
b)
Text Interface:
i.
Via Telnet:
Telnet to the NBB’s default IP address
(192.168.168.168). The Plug Status Screen (Figure 3.2) should
be displayed.
ii.
Via Local PC:
Start your communications program (e.g.,
Hyperterminal) and then press
[Enter]
. The Plug Status Screen
should be displayed as shown in Figure 3.2. The default
communications parameters for the Console Port are 9600 bps,
No Parity, 8 data bits, One stop bit.
Содержание NBB-1600
