WPI PIMT201, Инструкция по эксплуатации

Страница: 7 / 32

PIMT201
World Precision Instruments 3
MICROSCOPE SETUP
Before setting up the microscope, carefully open the box and inspect its contents. The
pieces of the microscope are stored in two Styrofoam containers, and many of the
pieces are wrapped in plastic ( Fig. 2 ). Carefully unwrap each piece before setting up
the instrument. The following instructions graphically show how to setup your inverted
microscope.
NOTE : If you have a problem/issue that falls outside the definitions of this manual,
contact the WPI Technical Support team at 941.371.1003 or technicalsupport@wpiinc.
com.
Setting up the Base and Stage
1. Remove the base of the microscope and set it up on a firm tabletop surface ( Fig.
3 ). Fig. 4 shows the back of the microscope base. The A/C power plug adapter,
the serial number and the fuse compartment are located on the back. Fig. 5
shows the power switch and lamp brightness control located on the side of the
microscope.
Condenser Mount
Lamp Connector
Head Mount
Stage
5-Position Nosepiece
Focus Control Knob
Front Back
Fig. 3—Base of the microscope.