WPG MRTALP410TDC3, Руководство по эксплуатации

Страница: 19 / 48

Rev 1.0/2-21 MRTALP4-DC3: #35058AUS 17
T
O
A
TTACH THE
P
ADS TO A
L
OAD
Make sure that the contact surfaces of the load
and the vacuum pads are clean (see ).
Positioning the Lifter on the Load
Attach lifter to load as directed below. Failure to follow instructions could result in
load damage or personal injury.
1) Attach the lifter to the load “on center” or “above center”, as required:
•
1A
To rotate and tilt
loads normally,
center the pad
frame on the load
(“on center” —
fig. 1A).
1
•
1B
To tilt loads lengthwise from the flat to upright
orientation, center the pad frame from left to right on
the load, and position the vacuum pads toward what
will be the top end when upright (“above center” —
fig. 1B). The load will automatically tilt to the upright
position when lifted.
2) Make sure all vacuum pads will fit on the load and will be
loaded evenly.
3) Place the vacuum pads in contact with the load surface.
1..... The lifter is designed to handle the maximum load weight when the load’s center of gravity is positioned within 2" [5 cm] of the lifter’s rotation
axis. Off-center loads may rotate or tilt unexpectedly.
OPERATION