Cordless self-propelled lawn mower EN
15
14
15
14
power.
NoTE: if the battery is defective, the
red light on the charger will flash.
The lights will only function when
the charger is connected to both the
battery and wall receptacle.
7. The charger is a smart charger and can
stay connected to the battery and wall
receptacle for extended periods of time
without fear of damaging the battery or
charger. The charger will automatically
cycle on and off periodically to ensure the
battery is fully charged.
baTTEry CarE
The battery in your cordless lawnmower is a
36-volt sealed lead acid system. The mower
can be stored in any position without fear of
leakage.
• For optimal battery life and performance
the battery should be fully charged every 2
months during storage
• For optimal battery life and performance
the battery should be fully charged after
each use
• Store the battery in a cool dry location.
• The battery can be safely stored down to
14°F (-10°C).
• The battery does not need to be fully
discharged before recharging.
• Initially 2 to 3 charging cycles may
be required after purchase to achieve
maximum run time capacity.
The battery is maintenance free.
ADDITIONAL BATTERIES can be obtained
from the Customer Helpline 1-866-354-
9679.
ASSEMBLY/ADJUSTMENT
warNiNg!
Do not connect the battery
and/or the safety key before product is
completely assembled.
1. aSSEmbliNg ThE haNdlE (See C1,
C2)
Remove the packaging endcap (see C1).
Raise the handle section into place and secure
by tightening the two locking cam levers.
Check that the handle is FULLY secured.
The cam lever (6) pressure can be adjusted by
rotating the screw knob (14) clockwise/counter-
clockwise. DO NOT OVER TIGHTEN.
2. aSSEmbliNg ThE graSSbag (See
d1, d2 & d3)
1) Before starting to assemble the grass bag
to the frame (b), check that the grass bag is
positioned to slip over the frame.
2) Slide the grass bag onto the frame.
3) Assemble the top clips to the frame, then
assemble the two side clips and the bottom
clip.
3. FiTTiNg/rEmoviNg baTTEry (See
E1, E2)
rEmoviNg baTTEry
Disconnect the battery connector (e), then
rotate the battery locking knob (d) counter-
clockwise. Remove the battery by lifting it out
of the mower by the battery handle. (See E2)
NoTE:
Be careful not to drop the battery onto
your foot or on the ground when removing it.
FiTTiNg baTTEry
Put the battery into the battery container,
connect the battery connector (e) and then
rotate the battery locking knob clockwise (d).
(See E1)
4. haNdlE adjUSTmENT (See F)
The upper handle can be adjusted to 3
different height positions. Depress the locking
cam lever, set the upper handle to one of the
three height positions, and make sure to insert
the pin into the hole. Then release the locking
cam lever.
NoTE:
Always check that the upper handle is
fixed firmly.
5. iNSTalliNg ThE graSS bag (See
g1, g2 & g3)
FiTTiNg
1) Turn the mower off, wait until blade stops
and remove safety key.
2) Raise the safety flap and hold it up, ensure
that the mulching insert has been removed.
3) Pick up the grass bag by the handle, and
position grass bag on the two lower
grommets (f) on the bottom edge of the
mower deck. Raise the bag to its full
Содержание WG789
