Worx WG602, Руководство пользователя, Страница: 11 / 24

Electric Pressure Washer EN
11
MAINTENANCE
Remove plug from the socket before carrying out any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or worn parts. Contact
your supplier or the manufacturer for replacement parts.
Power cord maintenance
If the electrical cord is damaged, do not attempt to repair yourself; call the Worx solutions center for further assistance.
Pump maintenance
Inspect the pump frequently whether any leaking occurs around the pump seal. If leaking occurs, contact the solutions center
for further assistance.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible obstructions using the included declogging needle (See Fig.
L).Then use a garden hose to rinse the nozzle by backwashing
WARNING
: Any other servicing should be performed by an authorized service representative.
STORAGE
1. Disconnect the water source. Turn on the pressure washer for a few seconds until the remaining water flows out. Then turn
it off quickly.
2. Unplug the power supply .Wind power cord on the tool and use power cord clip to fix . (See Fig.J1)
3. Disconnect the high pressure hose and the garden hose (not supplied), and coil high-pressure hose for storage. Insert the
Wand and lance separately into the Wand Holder and lance holder. (See Fig.M)
4. Store in a frost free area with a temperature above 0°C(32°F).
TROUBLESHOOTING
Symptom Possible causes Solution
Machine does not start
when the switch is in”
I”position.
Power cord is not plugged in. Plug in power cord.
Socket is defective
.
Check or replace plug, socket, fuses.
GFCI is triggered. Press reset on GFCI plug.
Machine pressure is
not consistent.
Pump is faulty. Contact service center .
Air in line. Remove the nozzle, turn on the machine for a while and
install the nozzle back.
Water inlet adapter is clogged
or dirty.
Remove the adapter, rinse it with water and put is back.
The pressure of the
pump is not adequate
Water supply is Insufficient. Open water source completely.
Water supply is restricted. Check If the water hose kinks or leaks.
Diameter of garden hose is too
small.
Replace with right garden hose .
Leak or kick in hose . Replace hose or untie kinks in hose.
Lance leaks O-ring needs to be replaced (See
Fig. A1) . .
Replace o-ring .If the problem is not solved ,contact service
center to buy a new lance.