Worx Landroid WR147, Руководство пользователя

Страница: 35 / 104

35
EN
Landroid wheels skid or repeatedly
slip. Foreign obstacles, such as twigs and
branches may be lodged under
Landroid. Remove foreign objects from underside of
Landroid.
The lawn is too wet. Wait until lawn has dried.
Landroid runs outside the boundary
wire. The boundary wire of another Landroid
or robotic mower is positioned too
closely. Ensure at least 3.2 ft. minimum distance
between your boundary wire and that of your
neighbor.
Landroid reverses or rotates
erratically near the boundary wire. There is boundary wire electric signal
leakage due to broken insulation. Repair damaged boundary wire
with the wire connectors supplied.
Landroid slips out of its working
area going down a hill.
Low grip of Landroid drive wheels. Please check that the wheels are clean and
free of mud in order to have the maximum grip
possible.
Landroid system crashes when
charging or on standby. Software or display fault. Restart Landroid.
Landroid shuts off when docking in
the charging station. Landroid fails to charge due to over
temperature protection and is powered off. Place the charging station in a shady area or
wait until the temperature has cooled down.
Poor connection. Check the LED light on the charging station.
Check the connection between the
contact paddles located on the charging station
and the charging contacts on the mower.
Landroid stops in the working area. There is an obstacle in the working
area.
Remove the obstacle from Landroid’s working
area.
The cutting height is set too low for the
length of the grass or the grass is too
dense. Raise the cutting height and then
gradually lower.
The extended boundary wire should not
exceed (984 ft.) or it may cause signal
problem. Reduce the length of the boundary wire.
The distance between the center of
the lawn and the boundary wire should
not exceed 82ft. or it may cause signal
attenuation. Reduce the distance between the
center of the lawn and the boundary wire
perimeter within 82 ft.
Landroid flips over. There is an inclined obstacle on the lawn. Exclude the obstacle from Landroid’s working
area.
Landroid fails to connect to the
internet. Please check your router has the
correct settings. Make sure your router frequency is 2.4GHz. If
your router has two settings, please enable the
2.4GHz frequency band.
Make sure your router is set to 802.11 mode
and wireless setting is b/g/n mixed.
Make sure your router has the SSID Broadcast
function enabled when you connect the
machine with the app.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to
connect Landroid to the new network.
Please check whether the router is
disconnected or WIFI SSID is changed Make sure the router is connected and WIFI
SSID is correct
Quick reference