Lawn Mowing Robot
EN
19
13. Fault symptoms
If your Landroid
®
does not work correctly, follow the trouble shooting guide below. If the fault persists, contact your Dealer.
Symptom
Cause
Action
Landroid
®
turns on, but the Blade
Disc does not move.
Landroid
®
is searching for the Charging
Base (except that you press the HOME
button to make it go to the charging
base, or the “Enable boundary cut”
function is operating).
This is normal, Landroid
®
needs to recharge,
the Blade Disc does not rotate while it is
searching for the Charging Base automatically.
Landroid
®
vibrates.
Blades may be damaged. Check
condition of the Blade Disc.
Check the Blades, and replace them if damaged.
Remove debris and foreign objects from the
blades and blade disc.
Grass is being cut unevenly.
Landroid
®
does not work enough hours
per day.
Add more hours to the mowing time.
Mowing area is too big.
Try decreasing the size of the mowing area or
adding more hours to the mowing time.
Blades are dull.
Change all the Blades and screws in order to
balance the Bade Disc.
The cutting height is set too low for the
length of the grass.
Raise the cutting height and then gradually
lower.
Grass or other object has wrapped
around the blade disc.
Check the Blade Disc and remove the grass
or other object.
There is a build-up of grass in the Blade
Disc or Motor Frame Box.
Make sure the Blade Disc rotates easily. If
need be, you may take off the Blade Disc and
then remove the debris.
The LED light on the Charging
Station does not turn on.
There is no power.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Green light flashing on charging
base.
The Boundary Wire isn’t connected.
Check that the Boundary Wire has been
connected correctly to the charging base.
Check there are no breaks in the boundary
wire.
Your Landroid
®
is inside its
territory and the boundary wire
is connected. The error indication
light flashes red.
The boundary wire ends are clamped
incorrectly.
Reverse the boundary wire ends.
The charging time is far more
than 2h.
Poor connection caused by debris on
the Charging Strip.
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
Landroid
®
using a cloth.
The charging protection program has
activated due to high temperature.
Place the charging base in a shady area or
wait until the temperature has cooled down.
The mower does not charge.
There is no power.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Does not operate correctly while
manually charging.
Refer to manual charging.
Landroid
®
is starting to have
shorter run-times between
charges.
Something is clogged in the Blade
Disc.
Take off the Blade Disc and clean it
The grass is too high and too thick.
Landroid
®
is shaking heavily.
Check the blade disc and blades, remove
debris and foreign objects from the blades
and blade disc.
The battery may be exhausted or old.
Replace battery.
