Worldline Six VALINA, Руководство по интеграции, Страница: 15 / 24

15
Step 4: Power up VALINA and fasten cables
The VALINA requires an external power supply, using one
of these three options:
• connector 1 – 12 V DC 2A (RJ45 connector)
• connector 5 – 12 V DC 2A (Microfit connector)
• connector 6 – 24–45 V DC (MDB connector)
NOTE
The VALINA cannot be powered through any other port.
To reduce wear on the connectors, use a cable tie to fasten
the cables to the strain-relief points on the VALINA
mounting- plates.
Figure 10: Strain-relief points on VALINA mounting-plates
NOTE
In normal state, the status LED on the front of the VALINA
lights up steadily as soon as you power up the terminal.
In tampered state, the device displays a warning message
and it is not possible to use the terminal to make a payment.
When a warning message is displayed:
1. Remove the terminal from service.
2. Contact your local service team immediately.
3. Keep the terminal available for possible forensic
investigation.
Step 5: Install SAM card – optional
The VALINA has two type ID 0 SAM slots.
• Install any SAM card before installing the optional commu-
nications board.
• Install both the SAM card and the communications board
before installing the VALINA in the vending machine.
1. Open the TELECOM cover
Remove the retaining screw of the TELECOM cover
and open the cover.
6 MDB
1
1
Figure 11: VALINA with TELECOM cover
1
in place
2. Open the SAM holder and insert SAM card.
Open the SAM holder (with the two bar-code labels on)
and insert one or two SAM cards as shown.
Make sure the card is completely inserted.
6 MDB
Figure 12: Fitting SAM cards
3. Close all slots.
Close the SAM holder, and press it down until it engages
with an audible click.
4. Close the TELECOM cover.
NOTE
If you will be installing the optional micro SD card or the
optional communications board, do not close the TELECOM
cover yet.
If you are using a retaining screw for the cover, use one
8 torx screw (included). Do not over-tighten the screw.