Worldlawn WYRZ50, Руководство оператора

Страница: 18 / 40

13
·Battery contains sulfuric acid. Avoid contact and always shield eyes, face, skin, and clothing
from battery. Cigarettes, flames, or sparks could cause battery to explode.
·Do not charge or use booster cables or adjust post connections without proper training.
·If battery acid comes in contact with skin or eyes, flush with water and call a physician
immediately.
·Keep out of reach of children.
3.3 INSTALL DRIVE WHEELS AND CHECK TIRE PRESSURE
a) Check air pressure in drive tires. Proper inflation for tires is12psi (82.8kpa)
b) Check air pressure in front tires. Proper inflation for tires is 25psi (172.5kpa)
3.4 INSTALL SEAT
a) Remove the seat assembly from the crate and four M8
×
25 bolts, four 8mm flat washers, and four 8mm
spring washers from the plastic bag.
b) Install four M8
×
25 bolts through flat washers, spring washers, and into the four holes in the seat
bracket and thread them into the four threaded holes in the bottom of the seat and tighten them.
3.5 INSTALL MOTION CONTROL LEVERS
a) The control levers were dismantled for shipping. Remove the control levers from the crate and four M8
×
25 bolts, four 8mm flat washers, and four 8mm spring washers from the plastic bag.
b) Place the right control lever to the outside of the control arm shaft, insert the bolts into the holes with
flat washers and spring washers and tighten them. (See Figure 2)
c) Install the other side the same way.
NOTE: There are two lever height options available. Place the levers in the first and the third
hole (from the top) to increase height of the levers or in the first and the third hole (from the
bottom) to decrease the height of the levers.
d) If the levers do not align with each other, when in the neutral position, loosen the hardware and make
the appropriate adjustment by sliding the lever forward or backward until properly aligned and tighten
hardware.