HANGZHOU WORLDE DIGITAL PIANO CO.,LTD HANGZHOU WORLDE MUSIC ELECTRONIC CO., LTD
WEBSITE: WWW.WORLDE.COM.CN EMAIL:[email protected] TEL:86 571 88730848
and select the very controller LED shows the controller No. of current controller. Input the desired
controller No. with Value Dial (e.g. when a dial is selected, LED shows the default
No. 007. If you input 010, the dial is assigned as PAN).
Operation steps are same as 2.5.2.
3.2.3 GM
Press EDIT button to enter keyboard multi-function mode. Press the GM ON function button to send GM ON message
F0 7E 7F 09 01 F7). The LED shows ‘Done’ when the message is sent.
3.2.4 GS
Press EDIT button to enter keyboard multi-function mode. Press the GS ON button to send GM ON message
F0 41 10 42 12 40 00 7F 00 41 F7). LED shows 'Done' when the message is sent.
3.2.5 XG
Press EDIT button to enter keyboard multi-function mode. Press the XG ON button to send XG ON message
(F0 43 10 4C 00 00 7E 00 F7). LED shows ‘Done’ when the message is sent.
3.2.6 Reset
Press EDIT button to enter keyboard multi-function mode. Press Reset button to reset the system restoring to factory
setting, sending system initial setting info at the same time.
3.2.7 SNAP SHOT
Press EDIT button to enter keyboard multi-function mode. Press SNAP SHOT button to send message of all user
settings.
3.2.8 PEDAL POLARITY
System can recognize or change pedal polarity. If you want pedal to transmit PEDAL ON message while pressing the
pedal and PEDAL OFF message while releasing the pedal, you do not need to do any adjustment. Otherwise, you can
press down the pedal while switching on this unit and release the pedal after the unit is turned on.
Press EDIT button to enter keyboard multi-function mode, and press C.PEDAL POL to adjust pedal polarity. The LED
displays “ON” when the function is on.
The operation steps and LED displays the following:
(1) Press EDIT button to enter keyboard multi-function mode.
(2)Press the “C.PEDAL. POL” button to start the function and the LED displays “ON”.
(3)Press the EDIT button and then “C.PEDAL.POL” button again to close the function and the LED will display “OFF”.
