World Cat 255 DUAL CONSOLE 2015, Руководство пользователя

Страница: 56 / 92

2015 World Cat 255DC Owners Manual
Page 10-55
10.1.2 Control System
Your 255DC comes equipped with the rocker control system discussed in section 6.8.6 of this manual. The rocker
panel is located on the console forward and outboard of the helm.. The control unit and accessory fuse block are
mounted on the rigging wall behind the console insert and can be accessed through the opening beneath the helm.
7KHERDW¶VZLULQJKDUQHVVHVDUHFRQQHFWHGWRWKHFRQWUROXQLW$IXVHEORFNLVSUR
vided for accessories not controlled
by the control system through a terminal strip. The terminal strip is labeled, to make it easier to identify the circuits.
10.1.3 Bilge Pumps / Float Switches
Your 255DC is equipped with two 1500 GPH bilge pumps. Each pump is connected to a float switch which
automatically triggers the pump when water comes to rest in the bilge. The float switches are connected to the
battery management panel through the hull harness and receive power from the breakers along the right side of the
panel. These breakers are constantly energized and ensure the safety of your boat even when the battery switches are
LQWKH³RII´SRVLWLRQ7KHSXPSVFDQEHPDQXDOO\HQJDJHGXVLQJWKHVZLWFKSDQHOORFDWHGRQWKHFRQVROH
The bilge pumps are located behind the aft rigging compartment and can accessed through the inspection plates in
the motorwell, forward of the engines. The wiring for these pumps is secured on the inboard side of the centerline
stringer which is visible from the inspection port.
Inspect the operation of your bilge pumps and their connections at least annually. To do so, activate the pump by
momentarily lifting the arm on the float switch, then check the operation using the switch pod. When testing, do not
allow the pumps to run dry for more than two to three seconds. Extended dry operation can result in damage to your
pump. Keeping your bilge areas clean can also help extend the life of your pump.
10.1.4 Freshwater System
The freshwater pump and wiring are located in the aft rigging compartment on the portside and can be accessed
through the inspection hatch beneath the portside aft seat. The freshwater pump is connected to the 10 gallon
freshwater tank located under the helm. To access the fittings, use the inspection port located in the starboard storage
compartment forward of the helm. The tank is filled through a fitting located on the gunnel outboard of the helm
chair. Similar to residential well pumps, the freshwater pump pressurizes the system to 45 psi. then shuts down until
the pressure drops below that level.
0RVWRZQHUVOHDYHWKHSXPS³RQ´WKURXJKRXWWKHGD\DQGXVHWKHV\VWHPZKHQ
necessary. On the 255DC, the freshwater pump feeds the cockpit shower located on the port transom wall and the
marine head. To view the layout of the freshwater system see the drawing in section 10.4.3.
10.1.5 Seacocks
Ball valves (seacocks) are installed on the water intake for the livewell and raw water system. The seacock must be
in the open position for these systems to work. When open, the handle will be parallel to the valve. In the closed
position the handle is perpendicular to the valve (see picture below). World Cat recommends that the seacocks
remain in the closed position when not in use, or when the boat is left unattended to prevent the vessel from taking
on water due to a plumbing failure.