Workzone 1544062, Руководство по эксплуатации

Страница: 18 / 32

18
Instructions
6
CAutIoN: Always use tongs, pliers or a similar tool to remove used,
hot electrodes or to move hot welded workpieces. Ensure that the
electrode holder is placed on an insulated surface when taking a break.
Always turn off the welder after finishing work and during breaks,
and always disconnect the machine from the mains.
GB Ire WZAW 150
0151 649 1500 1890 946 244 www.einhell.co.uk
After SAleS Support
Welding
• Proceed as follows after connecting the electrical connections
as described:
- Hold down the lever on the electrode holder and slide the
uncovered part of the electrode into the electrode holder.
- Clamp the earth cable to the workpiece. Ensure that a good electrical
connection exists between the workpiece and the earth clamp.
- Switch the machine on and adjust the welding current with the hand
wheel. The welding current must be selected according to the size
of the workpiece and the type of electrode.
- Hold the face shield in front of your face and strike the tip of the
electrode on the workpiece as if you were lighting a match. This is
the best method to start the arc.
CAutIoN: Do not bang the electrode on the workpiece as this
could damage the electrode covering, making it more difficult
to prime the arc.
- As soon as you have started the arc, try to keep the arc length
constant. The arc length should be approximately 1 - 1.5 times the
diameter of the electrode. The arc length should be kept as constant
as possible. Hold the electrode at an angle approximately 70° - 80°
to the workpiece.
19