Worksite 68125166, Руководство оператора

Страница: 20 / 25

ENGLISH
FUNCTIONAL DESCRIPTION
SPECIFICATIONS

Use only a pressure-regulated compressed air source to limit the air pressure
supplied to the tool. The regulated pressure must not exceed 110 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 120 PSI. The
tool could explode which will cause death or serious personal injury.

Always disconnect air resource:
a) Before making adjustments.
b) When servicing the tool.
c) When clearing a jam.
d) When tool is not in use.
e) When moving to a different work area, as accidental actuation may occur,
causing injury.

Never connect to an air source that may exceed 180 PSI. Over
pressurizing the tool may result in bursting, abnormal operation, breakage
of the tool or serious personal injury. Use only clean, dry, regulated
compressed air at the rated pressure or within the rated pressure range as
marked on the tool. Always verify prior to using the tool that the air source has
been adjusted to the rated air pressure or within the rated air-pressure range.

Drives 15-1/2 gauge flooring staples 1-1/2” to 2” (38 – 50 mm) and 16 gauge T &
L cleats 1-1/2” to 2” (38 – 50 mm)

Operating pressure: 70-110 PSI

Max.pressure 120 PSI

Air consumption: 5 CFM @ 90 PSI

Magazine capacity: T & L cleat nails: 100 pcs
Crown staples: 120 pcs

Air inlet: 1/4" (6 mm) NPT
ACCESSORIES

Air Tool Oil

4 Hex Keys

Wrench

Mallet

Air Plug (Pre-attached)

Foot plate
Figure 1 names the major components of the Flooring
Cleat Nailer/Stapler.
A.
Hand Grip
B. Arm
C. Hammer Cap
D. Air Cap
E. Body
F. Foot Plate
G. Shoe
H. Pusher
I. Magazine
J. Air Plug
Fig.1
A
F
G
H
I
J
B
C
E
D
IMPORTANT SAFETY INSTRUCTIONS
20