Worksite 68125166, Руководство оператора

Страница: 21 / 25

ENGLISH
ASSEMBLY
ASSEMBLING THE ARM
1. Set the arm (1) to the middle of handle. (Fig.2)
2. Fix the long-set bracket (2) into the hole on the arm. (Fig.3)
3. Put the washer (3) into the bracket and tighten the screw nut (4). (Fig. 4)
4. Insert the washer (3) into the bracket on the opposite side then tighten the screw nut
(4). (Fig. 5)
5. Check that four nuts and two brackets are fully tightened, and the arm is
fixed firmly.
CHANGING THE FOOT PLATE (Fig.6)
WARNING!
Disconnect the tool from the air source whenever changing the foot
plate. Make sure there is no fastener in magazine before changing the foot plate.
1. Disconnect tool from air supply.
2. Empty the magazine completely.
3. Fire the tool into a piece of scrap wood to ensure there are no fasteners
left in the tool.
4. Set the tool on its side to expose the three screws.
5. Remove the three screws, then remove the foot plate.
6. Align the three screw holes in the replacement foot plate with the three
threaded mounting holes.
7. Use the three screws previously removed to secure the replacement foot
plate to the tool.
Fig.2
Fig.3
Fig.4
Fig.5
!
Fig.6
Foot plate
Screws
Plate
screws
on nose
21