Worksaver SG-26A, Руководство по эксплуатации для владельца

Страница: 18 / 42

17
This unit is shipped almost completely assembled.
Carefully follow instructions for final assembly.
Before attempting assembly check the following items.
Having all the needed parts and equipment readily at
hand will speed up your assembly task and will make the
job as safe as possible.
• Refer to the repair parts drawing in this manual to get
an idea of how the parts need to be assembled for
each individual implement model.
• Check for fasteners and pins that were shipped with
the stump grinder. All hardware coming from the facto-
ry has been installed in the location where it will be
used. If a part or fastener is temporarily removed for
assembly reasons, remember where it goes. Keep the
parts separated.
• Have a fork lift or loader along with chains and safety
stands that are sized for the job ready for the assem-
bly task.
• Have a minimum of 2 people at hand during assembly.
• Check to see that all nuts are tightened.
Never let anyone stand between the rear of the tractor
and the stump grinder while the tractor is backing up.
Always stand to the side until tractor has come to a com-
plete stop and the brakes set or the tractor shift placed in
“PARK.”
1) Back tractor to align lift arms with stump grinder hitch
points.
2) Attach both lower lift arms to stump grinder. Secure
with linch pins. Tractor lift arm stabilizer bars or sway
blocks must be used to control side movement of the
stump grinder.
DO NOT CONNECT THE PTO DRIV-
ELINE AT THIS TIME.
3) Install suitable top link between tractor and stump
grinder. Secure with link pins and linch pins.
4) Lift stump grinder and check to see that both 3 pt. lift
arms are the same height. Adjust using crank if nec-
essary to level the implement from side to side.
To avoid bodily injury caused by accidental falling
of stump grinder, securely support stump grinder on
safe supporting stands or blocks!
INSTRUCTIONS
(continued)
1. Drive Shield
2. Bolt
3. Nut
4. Gearbox Input Shaft
5. Gearbox Input Shield
Figure 2. Slip Clutch Driveline Installation
Align the holes in the driveline yoke and the groove in
the gearbox input shaft and install bolts (2) and nuts (3).
Lubricate rear driveline half and install front driveline
half.
In some cases it will be necessary to shorten the PTO
assembly to match your particular tractor. The following
procedure should be used:
1. Raise the tractor 3 pt. hitch so the input shaft of the
gearbox is in line with the PTO shaft on the tractor.
Shut down tractor, leaving stump grinder in position of
shortest distance between shafts.
SECURELY
BLOCK IMPLEMENT IN POSITION.
TRACTOR 3 PT. ASSEMBLY
AND MOUNTING
——————————————————
PTO DRIVELINE INSTALLATION
——————————————————
On new stump grinders, check PTO driveline for correct
length for use with your tractor. (Read page 18.)
Most swinging drawbars will have to be moved to a
forward position or removed. Check the tractor swing-
ing drawbar for interference with the PTO driveline before
attempting to lift the stump grinder with the 3 pt. hitch.
Tractor lift arm stabilizer bars or sway blocks must be
used to control side movement of the stump grinder.
A new slip clutch, or one that has been in storage over
the winter may seize. Before operating, make sure it will
slip. Refer to slip clutch adjustment on page 27.
CAUTION