4
DAILY CHECKLIST
■
■
Check that stump grinder is properly and securely
attached to tractor.
■
■
During inspection, check that all nuts and bolts are
secure and that all safety shields are in place.
■
■
It is very important that the cutting teeth and cutting
tooth bolts are checked and tightened frequently.
■
■
Check condition of grinding wheel and security of
attachment.
■
■
Do not put stump grinder into service unless cutting
teeth edges are intact and in good repair.
■
■
Do not put stump grinder into service unless all
shields and guards are in place and in good condi-
tion. Replace if damaged.
■
■
Make sure spring-activated locking pin or collar
slides freely and is seated firmly in tractor PTO
spline groove.
■
■
Consult local utilities before working. Know location
of all underground cables, pipelines, overhead
wires, and other hazards in working area and avoid
contact.
■
■
Always wear relatively tight and belted clothing to
avoid entanglement in moving parts. Wear sturdy,
rough-soled work shoes and protective equipment
for eyes, hair, hands, hearing, and head.
DELIVERY CHECKLIST
Inspect the stump grinder thoroughly after assembly to
be certain it is set up properly. The following checklist is
a reminder of points to inspect. Check off each item as it
is found satisfactory or after proper adjustment is made.
■
■
Check operator's manual and familiarize the opera-
tor with all sections of it.
■
■
Check that all safety shielding is in place.
■
■
Check all bolts to be sure they are tight or adjusted
properly at hinged locations.
■
■
Check that all cotter pins are properly installed.
■
■
Check PTO driveline. Make sure it is the correct
length to operate stump grinder with intended trac-
tor.
■
■
Check that all lubrication points with grease fittings
have been lubricated.
■
■
Check that carbide teeth have been properly
installed. Check all cutting tooth bolts.
■
■
Check stump grinder attitude, after mounting on
tractor.
■
■
Check that gearbox is properly serviced and seals
are not leaking.
■
■
All safety signs (decals) in place and readable.
■
■
When the stump grinder is transported on a road or
highway at night or during the day, safety devices
should be used for adequate warning to operators of
other vehicles.
CHECKLISTS
IMPORTANT!
Gearbox was not filled at factory. It must be serviced before operating. Fill to
proper level with SAE 90 oil. Failure to service will result in damage to gearbox.
Содержание SG-26A
