21
Required tools:
(2) 9/16" combinaon wrench. (2) 1" square 31" long steel tubing or 31" long screen frame w/mesh
Set-Up on: A
: Insert 31" screen or (2) pieces of 1" steel tubing in the screen clamps. When using steel tubing, align outside
edges of steel 1" from the outside edge of screen clamp. When using a screen install normally. In manual mode raise table. Visually
inspect off contact between the steel (or Screen frame) and the pallet.
Adjustment:
If the pallet is not level with steel tubing or screen use the following procedure. Loosen the uppermost nuts on top of
the pallet aluminum. Use a 9/16th wrench to raise the pallet. Use the 9/16th nut on boIom side of the pallet aluminum base to
raise the pallet. If you need to, loosen the uppermost nuts on the Pallet Leveling Bolt even more do so. To lower the pallet use the
same nut used to raise it on the boIom side of the pallet bracket turning it in the opposite direcon. AKer raising or lowering the
pallet ghten the uppermost nut on top of the pallet aluminum base.
Important:
You must level all the pallets to the same print head. The three Leveling bolts are aIached to the holding brackets
secured to the Press. The holes for the three leveling bolts are sloIed so you can move the Pallet side to side as well. AKer you
have leveled all the Pallets, adjust the off contact on the remaining heads to the SAME Pallet.
