14
Sensors:
The sensor page will show what sensors are being made and not being made. If the table is in the up posion and the table down
sensor is reading down then the sensor is not being made.
In posion: The sensor that shows the bearings are all lined up.
Fork: The sensor shows whether or not the fork is on a bearing or pulled away from them.
Slow down: Is the input from the snap acon switch on the index track.
Switches:
From this screen you can test all of your switches. If the print head switches are turned off, heads 1—6 will register off or on .
Manual Print buIons, if pushed in, will register on.
Manual Mode switch. Print valve and Foot pedal can each be checked by turning the toggle switches on.
Missing shirt pedal can be stepped on and Index foot pedal can be stepped on to register if they are connecng to the computer.
This will normally be used as a test funcon to see if the computer is receiving the command when entered. A normal test would
be if you stepped on the foot pedal and nothing happened. You could go to the switches screen and when stepping on the foot
pedal you can see if the computer register's the input.
