SETUP AND MAINTENANCE OF
THE RECEIVER
15cm/6"
10cm/
4"
10cm/
4"
1.Provide spaces for sufficient ventilation as indicated:
3.Do not use your receiver immediately after transferring it from
a cold place to a warm due to there is risk of condensation.
4.Do not expose your receiver to water or excessively high te-
mperatures.
5.After having disconnected your receiver, clean the case with
a soft cloth, or with a slightly damp leather chamois. Never use
strong solvents.
PROTECT YOUR RECEIVER FROM
OVERHEATING
1.Do not block ventilation holes. Arrange the receiver so that air
can circulate freely.
2.Do not stack the receiver and other components directly on
top of each other.
3.Allow adequate ventilation when placing your receiver in a
stand.
4.Place an amplifier near the top shelf of the stand so heated
air rising from it will not affect other apparatus. If you have a
satellite receiver, you should place it on the top shelf.
10cm/
4"
15cm / 6"
15. Cleaning - Unplug this unit from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning.
16. Power lines - An outdoor antenna should be located
away from power lines.
17. Object and Liquid Entry - Care should be taken so that
objects do not fall and liquids are not spilled into the enclo-
sure through openings.
To CATV system installer's (U.S.
A.): This reminder is
provided to call the CATV system installer's
attention
to Article 820-40 of the NEC that provides guidelines
for proper grounding and,
in particular , specifies that
the cable ground shall
be connected as close to the
point of cable entry as practical.
Note:
IMPORTANT SAFETY INSTRUCTIONS
2.Do not connect to the AC power cords until all
are
completed.
apparatus
ST ER EO R EC EI VE R AMP LI FI ER
