CARE AND MAINTENANCE
No audio.
-
Make sure the MUTE indicator on the front panel is off.
-
Make sure the speakers are turned on.
-
Check the connections.
-
Check the short plug between
PRE OUT
jacks and
AMP IN
on the rear panel is inserted.
-
Check the power cord connection.
No audio from one channel.
-
Check the speaker wire connection or connecting cable.
-
Check the connection between the receiver and the speaker.
TROUBLESHOOTING TIPS
RECEIVER/TUNER OPERATION
-
Adjust the antenna.
-
The signal is too weak. Connect an external antenna.
-
The signal is Mono.
-
Sever hum or noise.
-
The signal is too weak. Connect an external antenna.
REMOTE CONTROL OPERATION
The remote control does not operate the unit.
-
Another function is selected on the remote. Press the correct
function button.
-
No batteries installed. Install the batteries before attempting
to operate the remote.
-
The batteries are exhausted. Replace all batteries.
-
The remote is not pointed at the remote control sensor on the
-
The remote control is too far from the main unit. Move closer.
main unit or there is an obstacle between the remote and the
main unit.
GENERAL
13
STEREO indicator is off.
NOTE:
Be sure to match the + and - ends of each battery to the symbols
shown in the remote battery compartment.
Noise when the TV is turned on.
- T
he TV too close to the unit.
- Disconnect the system from AC power before cleaning the
exterior of the system with a soft dust cloth.
CLEANING THE EXTERIOR
CLEANING THE EXTERIOR
