EN
OPERATION
Welding plastics:
Mount the reduction nozzle and the welding shoe. The workpieces to be welded and the welding rod must
be of the same material. The seam must be clean and grease-free. Carefully heat up the seam location until
it becomes doughy. Please note that the temperature difference between the doughy and liquid state of
plastic is low. Feed in the welding rod and allow it to run into the gap so that a uniform bead is produced.
Shrinking:
Mount the reduction nozzle. Select the diameter of the heat-shrinkable sleeve according to the workpiece.
Heat the heat-shrinkable sleeve evenly.
Defrosting water pipes:
Before heating pipes, check to make sure that it is actually a water pipe. Water lines often do not differ in
appearance from gas lines. Gas lines are not to be heated under any circumstances. Place on the angle
nozzle. Heat the frozen zone always from the outside to the middle. Heat up plastic pipes as well as
connections between pipe pieces especially careful to prevent damage.
