EN
OPERATION
CAUTION:
This tool is designed for indoor use only. Using this tool for prolonged periods may cause it to
overheat and malfunction. Use inside a confined area, such as a cabinet etc. Will increase the temperature
of the tool
–
to ensure the tool does not overheat it is suggested frequent breaks are taken to allow the
tool to cool down.
Only use the prescribed purposes. Any other use is considered as a case of misuse. The user / operator and
not the manufacturer will be responsible for any damage or injury caused by this improper use. Remember
that this device is not designed for commercial or industrial use. The guarantee will not be valid if the
equipment will be used for commercial, industrial or similar purposes.
Ensure the ON/Off switch is in the position “0“ before connecting to the power supply.
Switching ON/OFF:
- To switch the tool on, set the on/off switch to position I. Some smoke may be emitted after switching on;
this does not indicate a problem.
- To switch the tool off, set the on/off switch to position O. Let the tool cool down before moving or storing
it.
Temperature setting:
Turn ON/OFF switch to 1 or 2, depending on temperature you need. The heat gun will start to buzz.
Removing varnish/softening adhesives:
Mount the wide jet nozzle. Briefly soften the varnish applying hot air and remove it using a sharp, clean
scraper or putty knife. Applying heat too long will burn the varnish, making it more difficult to remove.
Many adhesives (e. g. of stickers) become soft when heated. Heated adhesives allow for bonds to be
separated or excessive adhesive to be removed.
