Worcester Greenstar 80mm Flexi RF Flue, Руководство по установке, Страница: 8 / 16

Installation
Greenstar 80mm Flexi RF Flue – 6721814542 2019/09
8
4.2 Installing the flue elbow support
Depending on the depth of the chimney, it may be necessary to cut the
support bar.
▶ Cut the support bar to fit the chimney as in fig. 9
▶ Drill a new hole into the support bar.
Ensure it will match with the securing hole in the ledge.
Fig. 9 Cutting the support bar
▶ Measure the depth of the chimney X.
▶ Position the elbow centrally on the elbow support at half of X as
shown in fig. 10
▶ Secure with the wing nut.
▶ Grease the seal in the elbow.
Fig. 10 Fitting the elbow to the support
▶ Place the elbow assembly in the chimney.
▶ Ensure that the elbow support is horizontal and the elbow centrally
positioned with the chimney space.
▶ Secure the assembly with a screw as shown in fig. 11
Fig. 11 Place the elbow assembly into the opening
4.3 Assembling the flexible flue
1. Apply silicon grease (3) to the seal (2) and fit the seal into the first
recess on the flexible liner (1), make sure that the seal is not twisted
and is seated properly.
2. Check that the locking lugs on the adaptor assembly (4) are fully
undone. If the adaptor is locked, push the locking tabs outward to
release the locking lugs from the adaptor.
Push the adaptor (4) onto the flexible liner (1), it may be necessary
to pull the locking lugs out to allow the adaptor to be pushed into the
flexible liner, until the adaptor “bottoms out”.
Ensure that the flexible flue:
– is pushed fully down
– is square with the adaptor
3. Push the locking tabs in until they click and lock in place.
4. If the adaptor assembly (4) needs to be removed after assembly then
the locking tabs can be opened with your finger to allow removal of
the flexible liner.
0010029911-001
0010029927-001
0010029914-001