Worcester 28CDi RSF, Инструкции по установке и обслуживанию

Страница: 12 / 36

The appliance is supplied suitable for fitting to a sealed system. If
it is to be fitted to an open vent system refer to section 8.
11.1 FLUE OPTIONS.
The standard flue length is from 100mm to 650mm measured
from the appliance casing to the outer wall.
Extension flue kits, a vertical take-off adaptor, 90° flue bends
and 45° flue bends are available to increase the length and
redirect the flue as follows.
The maximum flue length is 3000mm.
For each added 90° flue bend 1000mm of flue must be
removed.
For each added 45° flue bend 500mm of flue must be removed.
The flue turret can be replaced by a flue bend with no reduction
in flue length.
Flue components
1. Appliance casing sealing gasket
2. Flue Turret
3. Flue Collar
4. Air duct to turret sealing ring
5. Standard air duct
6. Standard flue duct
7. Restrictor ring
8. Flue terminal
9. Extension air duct
10. Extension flue duct
11. Flue duct sealing ring
12. In-line flue elbow
13. Vertical flue adaptor
IMPORTANT:
The restrictor ring must not be used for flue lengths over
650mm
The flue must be installed as specified in BS 5440 Part 1.
11. Installation
12
Fig. 15. Fixing the appliance to the wall mounting plate.
Fig. 16. Flue turret fixing and automatic
air vent.
Fig. 14. Fixing the wall mounting plate.
Pre-plumbing
manifold
Top fixing
screws (2)
Plumbing
manifold
fixing
screws (4)
drill lower
pair of holes
in cross
brace
Mark horizontal
line along here
425mm
822mm
800mm
99mm
Fixing screws (4)
Auto air vent
Flue gas
test point
Wall mounting plate
Appliance
Flue turret
Sealing
gasket
Keep appliance
vertical
Step 1. Rest appliance on
wall mounting plate and push
back, engaging valves first.
Step 2. Secure at top
with the M6 nuts and
washers supplied (2).
Step 3. Secure
at bottom with
caps and bolts
supplied (3).
211mm