Woodward MicroNet TMR 5009, Инструкция по установке/руководство по оборудованию

Страница: 105 / 118

Manual 85580V2 5009 Installation/Hardware
Woodward 97
To complete an interface with the 5009 control system, the panel must be
hardwired to the control and the control’s program configured to accept the
interface (contact I/O and analog inputs programmed). The 5009 control can be
programmed to use the DSLC as a synchronizer only, or as a synchronizer and
load sharing control. Refer to the DSLC Manual ( 02007) for device-specific
information.
DSLC Panel Installation
Mount panel near the control or unit switchgear within 300 m (1000 ft) of the
control, leaving an adequate service loop.
1. Mark the panel location and mounting holes, taking care to leave sufficient
space between the panel and walls, objects, etc. for easy access.
2. Drill and tap the mounting holes for appropriate size hardware (see Figure 8-
4).
3. Place the panel in position, insert the mounting screws into the tapped holes,
and tighten the hardware securely.
4. If the DSLC Panel is not at earth ground potential, connect it to earth ground
via a 4.0 mm² (12 AWG) or larger green/yellow wire or braid.
Figure 8-4. DSLC Mounting