Woodward Large Electric Sonic Valve II, Инструкция по установке и эксплуатации, Страница: 29 / 66

Manual 35076 LESV II
Woodward 27
For 3, 4, 6-inch LESV II grease ports, refer to Figure 3-2.For grease ports A-D, leave a minimum of
12 inches (30.48 cm) clearance for maintenance access. See Manual 35103 for additional lubrication
details.
For grease port E (the gun/needle): leave a minimum of 25 inches (63.50 cm) clearance for maintenance
access. See Manual 35103 for additional lubrication details.
Figure 3-2. Port Locations 3, 4, and 6-Inch LESV II
Lifting Procedures
Crushing Hazard
Carefully review the Figures 1-2a through 1-5b, and 3-3 and 3-4 for
lifting locations, weight, and center of gravity before moving the
LESV II. Do not lift or handle the actuator by electrical connections or
the SIL2 Flow Sensor.
The significant weight of the valve poses a crushing hazard that can
result in personal injury or death.
The LESV II is not designed to be a step or to support the weight of a
person.
While a single lifting eye is capable of supporting the weight of the LESV II, when lifting the valve from the
vertical position, Woodward recommends lifting the LESV II by the two lifting eyes shown in Figure 3-3.
The maximum lifting strap angle shown in Figure 3-3 is to prevent the lifting eyes and straps from rubbing
against the motor housing.
PROTECT ELECTRICAL CONNECTORS. If not properly protected,
electrical connector damage can occur during lifting and installation
of the LESV II.
Released