Woodward 9907-252, Инструкция по установке и эксплуатации

Страница: 10 / 36

Load Sharing Module Manual 02035
6 Woodward
Chapter 2.
Installation
Introduction
This section contains general installation instructions for the Load Sharing
Module. Environmental precautions and location considerations are included to
determine the best location for the Load Sharing Module. Additional information
includes unpacking instructions, electrical connections, and an installation check-
out procedure.
Unpacking
Before handling the Load Sharing Module, read page ii, Electrostatic Discharge
Awareness. Be careful when unpacking the Load Sharing Module. Check the unit
for signs of damage such as bent or dented panels, scratches, and loose or
broken parts. Notify the shipper of any damage.
Location Considerations
Consider these requirements when selecting the mounting location:
•
Adequate ventilation for cooling
•
Space for servicing and repair
•
Protection from direct exposure to water or to a condensation-prone
environment
•
Protection from high-voltage or high-current devices, or devices which
produce electromagnetic interference
•
Protection from excessive vibration
•
An ambient operating temperature range of –40 to +70 °C (–40 to +158 °F)
Do not mount the Load Sharing Module on the engine.
Figure 1-2 is an outline drawing of the Load Sharing Module. Install the unit as
close as practical to the electronic engine control, but
not
on the engine itself. It
may be installed in any position.
To maintain compliance with CE marking requirements, the European Union Low
Voltage Directive requires that the Load Sharing Module (LSM) be mounted in an
IP43 enclosure as defined in EN60529. Access to the Load Sharing Module must
be restricted to qualified personnel.