OPERATION
18
enter PIN (e.g., “1234”)
IJKL
wait for 2 beeps
Dial the number to be called (up to
30 digits) followed by a “
;
”. (enter
“
P
” before the destination number
to skip prefix)
QMM]8
]]];
stores the dialed digits, flash
hooks, dials the prefix (if any)
and the number
wait for DialMate to connect the
call
flash hooks, dials suffix (if
any) and connects the call
when the called fax machine
answers and gives a fax tone,
press the “start” button to initiate
the fax operation
START
replace the handset on its cradle
and watch the status of the call
to make another call after the
document has been confirmed
sent, pick up the handset
immediately and press “STOP” on
your fax machine
(only for non-
PABX DialMate installations)
enter “
;^
”
;^
wait for two beeps
enter the next number to be called
(e.g., “831-4444”) followed by “
;
”
^KIL
LLL;
connects the call
after successful transmission, pick
up the handset and press “STOP”
STOP
enter “
;H
”
;H
disconnects the call and goes
to idle mode
Call Back - Modem Operation
It is recommended that the voice message recorded in DialMate be erased before
starting modem operation since the voice playback might interfere with the
reception of the PIN code dialed by the modem.
Most modems are set up so that they will not dial a number if a dial tone is not
present. In this case, the modem string must be modified to enable the modem to
dial a number without the presence of a dial tone. For most modems, add “X0” or
“X3” to the AT command to prevent dial tone detection. Refer to your modem
manual for this modification.