Woodstock Shop fox W1856, Руководство пользователя

Страница: 39 / 52

-37-
Model W1856 (For Machines Mfd. Since 02/19)
SE
RV
IC
E
Replacing.Brushes
This machine is equipped with a universal motor that
uses a pair of carbon brushes to transmit power. These
brushes are considered to be regular "wear items" or
"consumables" that will eventually need to be replaced.
The frequency of this replacement is directly related to
how much the motor is used and how hard it is pushed.
These brushes are not covered under warranty.
Replace both brushes at the same time if the motor
no longer reaches full power, operates inconsistently,
or when the brushes measure less than
1
⁄
4
" long (new
brushes are
5
⁄
8
" long).
Items Needed Qty
Flat Head Screwdriver .........................................1
Precision Ruler ..................................................1
2-Pc. Brush Kit (X1856105) ....................................1
To replace motor brushes, do these steps:
1. DISCONNECT MACHINE FROM POWER!
2. Remove brush caps on sides of motor (see Figure
42
).
3. Remove brushes from motor (see Figure 43
).
Note:
When brush caps are being removed, a spring
will pop out of the motor socket; a spring is firmly
attached to each carbon brush. DO NOT separate
brush from spring.
4. Use a ruler to measure wear of each carbon brush.
If either brush is worn to less than
1
⁄
4
" in length,
replace both brushes.
5. Position each new brush assembly to slide into slots
in motor socket. Carefully push spring into motor
socket with brush cap, then tighten brush cap.
6. Test run machine.
— If machine runs properly, you are done.
— If motor does not start, either new brushes are
not correctly aligned in each socket, or there is
another problem with motor or wiring. Double-
check all wire connections first, then refer to
Troubleshooting on Page 38 for assistance.
Figure.43.
Removing brush from motor.
Figure.42. Brush cap locations.
Front Brush Cap
Rear
Brush
Cap