Woodstock Shop fox W1856, Руководство пользователя

Страница: 29 / 52

-27-
Model W1856 (For Machines Mfd. Since 02/19)
O
PE
R
ATIO
NS
6. Drive spur center into end center mark of workpiece
with a wood mallet to embed it at least
1
⁄
4
" into
workpiece, as shown in
Figure.27
.
7. With workpiece still attached, insert spur center
into headstock spindle (refer to
Installing/Removing.
Headstock.Center
on
Page.21
for additional
instructions).
Note: Use tool rest to support opposite end of
workpiece so that workpiece and spur center do not
separate during installation.
8. Install live center into tailstock quill and tighten
quill-lock handle to lock quill in position (refer to
Page.22
for additional instructions).
9. Slide tailstock toward workpiece until point of live
center touches workpiece center mark, then lock
tailstock in this position.
10. Loosen quill lock handle and rotate tailstock
handwheel to push live center into workpiece at
least
1
⁄
4
".
11. Properly adjust tool rest to workpiece (see Adjusting.
Tool.Rest
on
Page.20
).
12. Before beginning lathe operation, rotate workpiece
by hand to ensure there is safe clearance on all
sides.
1
/
4
"
Figure.27. Spur center properly embedded.
Do.not.press.the.workpiece.too.firmly.
with. the. tailstock. or. the. bearings. will.
bind. and. overheat.. Do. not. adjust. the.
tailstock. too. loosely. or. the. workpiece.
will. spin. off. the. lathe.. Use. good.
judgment. and. care,. otherwise. serious.
personal. injury. could. result. from.
the. workpiece. being. ejected. at. high.
speeds.
Keep. lathe. tool. resting. on. tool. rest.
the. ENTIRE. time. it. is. in. contact.
with. workpiece. or. when. preparing.
to. make. contact. between. lathe. tool.
and. workpiece.. Otherwise,. spinning.
workpiece.could.force.lathe.tool.out.of.
your.hands.or.entangle.your.hands.with.
workpiece..Failure.to.heed.this.warning.
could.result.in.serious.personal.injury.
Spindle.Turning.Tips
• When turning the lathe ON, stand away from the
path of the spinning workpiece until the spindle
reaches full speed and you can verify that the
workpiece will not come loose.
• Use the slowest speed when starting or stopping the
lathe.
• Select the right speed for the size of workpiece that
you are turning (refer to
Figure.20
on
Page.24
).
• Keep the turning tool on the tool rest the ENTIRE
time that it is in contact with the workpiece.
• Learn the correct techniques for each tool you
will use. If you are unsure about how to use the
lathe tools, read books or magazines about lathe
techniques, and seek training from experienced and
knowledgeable lathe users.
Eye. injuries. or. respiratory. problems.
can.occur.while.operating.this.machine..
Wear.personal.protective.equipment.to.
reduce.your.risk.from.these.hazards.