Woodstock Shop Fox W1805, Руководство пользователя

Страница: 32 / 48

-30-
Model W1805 (For Machines Mfd. Since 7/15)
M
A
INTE
N
A
N
CE
MAINTENANCE
The bearings in the machine are sealed and lubricated
for life. The spindle has one grease fitting that must be
greased approximately every 40 hours or one week of
regular use (refer to Figure.47 ). To grease the spindle,
connect the fitting to a grease gun and give the spindle
one pump of multi-purpose lithium grease.
Lubrication
Vacuum excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built up,
use a resin dissolving cleaner to remove it.
Protect the unpainted cast iron surfaces on the table
by wiping the table clean after every use—this ensures
that moisture from wood dust does not remain on bare
metal surfaces. Tables can be kept rust-free with regular
applications of a quality metal protectant/lubricant.
Cleaning
Daily.Maintenance.(8.Hours)
• Check/tighten cutter set screws.
• Clean debris/sawdust from clamps to ensure that
they do not interfere with the clamping ability.
• Clean/vacuum dust buildup off motor.
• Clean and lubricate unpainted cast iron portions of
the table and the headstock travel rods with a light
oil.
• Check/replace damaged power cords or wires.
• Check/add air tool oil to the air supply unit
lubricator.
• Check/drain the air supply unit water filter. (Drain
by sliding the white shaft to the other side.)
Weekly.Maintenance.(40.Hours)
• Grease spindle with multi-purpose lithium grease.
Monthly.Maintenance.(320.Hours)
• Belt tension, damage, or wear.
Schedule
MAKE. SURE. that. your. machine. is.
unplugged.during.all.maintenance.pro-
cedures!.If.this.warning.is.ignored,.seri-
ous.personal.injury.may.occur.
Figure.47.
Spindle grease fitting.
Spindle Grease Fitting