Woodstock Shop Fox W1805, Руководство пользователя

Страница: 29 / 48

-27-
Model W1805 (For Machines Mfd. Since 7/15)
O
PE
R
ATIO
NS
Vertical
Workpiece
Horizontal
Workpiece
Tail Thickness
Pencil Line
Make
Cutter Depth
Pencil Line
Here
Edge of
Horizontal
Piece Aligned
w/Pencil Line
(Side View)
Figure.41.. Marking horizontal workpiece
to set the cutter depth.
Vertical
Workpiece
Horizontal
Workpiece
Table Cutter
Pencil Line
Cutter tip at
farthest point
of rotation from
the side view.
(Side View)
Figure.42.. Cutter position to set cutter
depth stop (viewed from the side).
To.set.the.cutter.depth.stop,.do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
On a workbench, copy the "Tail Thickness" dimension
from the vertical workpiece to the horizontal
workpiece (
Figure.41
).
3.
Clamp the vertical workpiece in position on the
machine, then clamp the horizontal workpiece in
place against the vertical workpiece.
4.
Move the cutter to the right of the horizontal
workpiece and make sure the tracer pin is in the "in"
position.
5.
Rotate the cutter until the leading edge is at the
farthest point in rotation toward the rear of the
machine.
6.
From the right-hand side of the machine, look across
the table at the cutter position in relation to the
pencil line.
7.
Adjust the cutter depth bolt until the tip of the
cutter aligns with the pencil line ( Figure.42 ), then
tighten the hex nut.
Testing.Machine.Setup
Testing the setup requires you to make cuts and adjust
the cutter until the dovetail fit is perfect. Be aware that
the drawer you make during this procedure may end up as
scrap. To achieve good dovetails, you must have prepared
your stock as described in Stock.Preparation on Page.18 .
Continued on next page